Install louvered vent with flashing behind hardie plank
2015年5月9日 · The right way would be remove the siding, install the vent then reinstall the siding cutting it to fit around the vent. The siding can be removed by cutting the nails with off with a long bimetal sawsall blade slipped under the sidiing.
Installation Guidance | James Hardie
Find the technical documentation you need to build your James Hardie project from start to finish. From clearance requirements to installation videos to CAD files, we've got you covered.
James Hardie Install on Gable ends - DIY Home Improvement Forum
2013年12月22日 · I am fixing to install James Hardie siding on my home. I was curious how some of you have installed the rake trim (trim between soffit and siding). I see some where it has been capped over the siding and some where it is cut close and butts to the trim. If anyone has pictures that would be great also. Thanks in advance!!
mix hardi and wood? - Fine Homebuilding
2006年3月24日 · On my house I used Hardie Shingle for the body, Trex for the window and door trim, Hardie Fascia for the fascia, and ½" good-one-side MDO with standard aluminum strip vents for the soffit. They all worked well together, took paint well, and held up.
dryer vents, a block of HardieTrim@ 5/4, 4/4 boards should be installed around the point of penetration. TO install a block around an existing vent pipe, it may be necessary to cut the block into two pieces. In this case, weather-cut the trim to fit into place. Install flash- …
Hardie® Trim boards are decorative non-load bearing trim products. Do not use Hardie® Trim boards to replace any structural component. Wood or steel must be provided for attaching Hardie® Trim boards. Follow all appicable codes when installing Hardie® Trim boards.
Install Hardiplank siding with. OSB sheathing joints butted in moderate contact. Optionally, install the lap siding with a maximum 1/8” gap and caulk the joint ** (see detail at right). stud The first course of any wall should be installed over a 1/4” weather-resistive lath strip to ensure a consistent barrier * plank angle (see figure 1).
When using James Hardie siding, trim, and weather barrier products, make sure that roof flashing, water table flashing, window and door flashing, and flashing for other building envelope penetrations are properly installed and
During installation or handling: work in outdoor areas with ample ventilation; (2) use shears for cuffing or, where not teasible. use a HardieBIade' saw nlade and dust-reducing circular saw attached to a HEPA vacuum: (3) harn others In the immediate area, (4) wear a properly-fitted.
Siding already on wall- cutting into installed Hardi...
2014年6月19日 · To vent an attic I need to install some gable end vents into exterior walls already sided with Hardi Plank (or some other similar brand of plank that simulates beveled horizontal siding). The siding looks well installed, blind nailed.
- 某些结果已被删除