Help requested: SAA grip removal? | Colt Forum
2013年3月30日 · Put your triggerguard screw back in for a couple of turns, and give a tap with a light plastic or leather mallet - it should pop right off, and you can remove the screw. Then - push the opposite one off with a thumb from the inside.
Grip removal? | Colt Forum
2023年4月1日 · It can be tricky to remove the gripframe from the SAA without causing finish damage. This method works well for me. Things to gather before starting work: A piece of cardboard with 6 small holes, each labeled with a screw location (left hammer, right hammer, bottom, mainspring, left trigger...
Changing grips on saa 1873 or clones - Ruger Forum
2015年7月14日 · The new grips will come with a piece of wood or plastic that has to be epoxied or superglued into position to hold the grips tight against the frame (assuming you have two-piece grips). Take a look at the ones you removed and you will see how it works.
SAA grip fix | Colt Forum
2022年5月8日 · Fill the stock pin holes while you're at it and put some release agent on the actual pins, so you can remove the grips - you need to do this so nothing twists in recoil. Grip screws don't need to 'squeak' like lug nuts - keep that in mind. Another idea is to cut a furrel (bushing) to fit over the screw within the space between the grips.
Replacing "one piece grips" - The Firing Line Forums
2015年3月15日 · Try your new grips on the front strap. Trim them to fit. Then install the backstrap and trim the grips to fit. To prevent marring the straps, use a couple of layers of masking tape when fitting the grips. When the grips fit, remove the grips from the front strap, replace the mainspring and mainspring screw.
Slicking Up a Pietta 1873 Single Action Revolver
Remove the grip panel screw and remove the two grip panels. My guns had one-piece grips so I did not have to perform this step. Remove the three screws from the back strap; two from the top and one from the bottom.
Grip frame on SAA - AR15.COM
2008年2月28日 · Remove the grips if they're two piece with a screw. Remove the small screw on the bottom-front of the grip. Remove the two screws on either side of the hammer. Pull the …
removing handles from a colt SAA - The Firing Line Forums
2005年1月13日 · Replace gently, fitting the holes in the grip panels to the pins on the frame and squeeze with both hands to seat, then replace screw. Tighten snug, but carefully, you can pull the little metal bit (escutcheons) right through the grip panel if you're too enthusiastic.
Colt clone grip installation - The Firing Line Forums
2012年3月24日 · I recently purchased a Cimarron Arms Pietta Frontier .45 colt, a great Colt SAA clone. I want to replace the walnut grips with some simulated ivory antique grips, I ordered. This is a one piece grip assembly. My gun has a butt plate screw only.
EMF Hartford SAA - 1911Forum
2010年2月7日 · To remove the grips: Unscrew and remove the screw on the bottom front of the grip frame. Remove the two screws on the back strap, right beside the hammer. Pull the back strap and grips off. Pull the wood grip forward and out of the back strap.
- 某些结果已被删除