Helix plate diameters can vary from 6 to 16 inches for most commonly used shaft sizes. The majority of helix flights have thicknesses of either 3/8 or 1/2 inch, however, thicker plates are used for large diameter piles.
• Helix plate diameters may be between 8 and 14 inches with thickness between 3/8 inch and 1/2 inch. • Helix plates and shafts are smooth and absent of irregularities that extend more than 1/16 inch from the surface excluding connecting hardware and fittings. • Helix spacing along the shaft shall be between 2.4 to 3.6 times the helix ...
Helical plates are fabricated with Grade 50 steel. They vary from 6” to 16” in diameter and have a thickness of 3/8” to 1” depending on job requirements. The number and sizes of helical plates may be varied to match soil conditions to the required anchor capacity. When multiple helix …
Helical Anchors, Inc. recommends only using 85% of the Ultimate Torsional Strength shown above in table A for 2-3/8 to 3-1/2 helical piles. All other diameter helical piles are recommended to be use to 95% of their Ultimate Torsional Strength.
Available Helix Diameters: 8, 10, 12, or 14 inches. All helix plates are spaced 3 times the diameter of the preceding (lower) helix unless otherwise specified. The standard helix plate has straight sharpened leading edges or can be ordered with a “sea shell” cut.
Technical Manual - Foundation Supportworks, Inc.
The helix plate diameter, thickness and cut are selected based upon the soil and load conditions for the project. FSI currently offers: • Helix plate diameters ranging from 6 inches to 16 inches • Helix plate thicknesses of 5/16 inch, 3/8 inch, and ½ inch
Available Helix Diameters: 6, 8, 10, 12, or 14 inches. All helix plates are spaced 3 times the diameter of the preceding (lower) helix unless otherwise specified.
Available Helix Diameters: 6, 8, 10, 12, 14, or 16 inches. All helix plates are spaced 3 times the diameter of the preceding (lower) helix unless otherwise specified. The standard helix plate has straight sharpened leading edges or can be ordered with a “sea shell” cut.
Screw Pile Sizes: Standard Specifications For Your Project
2024年8月22日 · Helix plate thicknesses can range from 8mm to 36mm, ensuring that the screw piles can withstand different load-bearing pressures. The design loads and ground conditions are carefully considered by engineers to determine the appropriate helix …
Helix plates are pressed from standard structural rolled products in Grade S275, S355 or S450. The thickness of the plate can be from 10 to 35mm thickness depending on the necessary structural capacity required. The outside diameter of the …