Re-Coating Coated bullets - Marlin Firearms Forum
2023年7月27日 · Dump the gas and add water and dawn soap to rinse of the gas, let air dry and then coat them. the same works with lubed casts you want to powder coat. I've ordered some Missouri HiTek coated bullets and honestly, I don't believe they're double coated which HiTek coating recommends.
Sizing powder coated bullets - Cast Boolits
2016年8月18日 · If you have to recoat bullets after sizing powder coated bullets you're doing something wrong. The powdercoat should remain intact after being sized down in the bore and traveling 1000+ FPS. If your bullet can handle being fired in your gun it can handle your sizing die.
Powder coating cast bullets for dummies - Shooters' Forum
2023年7月2日 · You can recoat powder coat. In your case it may give you a better product as that so so first coat was over the top of a contaminated surface. A second coat will adhere to the first coat and blend.
Why & How To: Powder Coating Bullets - Sniper Country
2020年10月10日 · The easy way to powder coat bullets: First, start with non-lubed cast bullets… Next, put the bullets into a tumbling container and shake until all are evenly coated, about a minute… Bullets before “baking†Pour bullets and paint into a strainer/sieve, then shake the excess paint onto the cardboard… Removing extra paint
Powder coating cast bullets for dummies - Shooters' Forum
2023年7月2日 · Set a tray fabricated of 1/4" galvanized wire mesh with approximately 50 bullets loaded on it into the oven for 5 minuets. After 5 minuets I removed the bullets and dumped them into a plastic container (that displayed the coveted number 5 in a triangle on the base) with 1/3 cup of powder paint and shook the container for a minute.
How I powder coat my bullets. - The Firearms Forum
2019年12月5日 · After about 30 seconds to a minute of shaking I tap the lid to knock any powder off the inside and look at my bullets to see how they are coated. If they pass my inspection they should look like this or the ones in the white clear coat above.
Powder coating and Heat Treating. - The Art & Science of Bullet …
2020年8月28日 · Powder coating and Heat Treating. With the proper alloys, e.g., one with antimony and a little arsenic, one can heat treat to achieve BHNs up to 30. This is done by heat soaking the bullets in a convection oven for an hour at temps that can vary from 400* to 460* depending on the BHN desired, then quenching in water.
Powder Coating - Shooters Forum
2022年11月6日 · It took some time to place the bullets, but not as long as it had taken before to break up the cured-together masses. I baked at 400° × 20 min, and got perfectly coated bullets, which popped right off the teflon mat. Any gaps in powder closed right over during baking.
I NEED HELP WITH POWDER COATING - Cast Bullet Forum
2020年3月12日 · I have powder coated bullets baking out in the shop. I tried your idea about preheating the bullets. It worked, even with the Harbor Freight powder that isn't supposed to work.
Powder Coated Cast Bullets - Patriot Gun Builders Forum
2022年4月4日 · Powder coating makes shooting cast bullets as easy as jacketed and no more sticky lube, lube smoke, melted lube in summer temps, and leaded barrels and revolver cylinder faces. No gunking up the seating die on the Dillon anymore either.