Advice for new switches - The Meraki Community - Cisco Meraki
2024年4月4日 · Hello, I'm hoping someone will be able to give me some advice for replacing our old network switches. My current core switch has 4 SFP ports that are being used. I need to replace this old switch with a Cisco Meraki switch that has more than 4 10GB SFP ports. We are currently constructing a new bui...
IEEE 802.1W (PVST+) implementation on Meraki switches - Cisco …
2022年2月21日 · It has been said, with some evidence to back it up, that Meraki switches do not support true 802.1w per-VLAN Rapid STP. And in any case where a Meraki switch connects to a non-Meraki, specifically Cisco Catalyst or another vendor such as Aruba, that the non-Meraki switch should be configured with a single-instance of MSTP.
Meraki Switches - Break Apart Stacked Switch Setup? - Cisco Meraki
2023年8月18日 · We have a datacenter setup that's core backbone is setup with 2 MS225-48 Meraki switches in a stack with 10GB stack cables. Each switch has its own 1GB uplink cable to the firewall but of course one of them is discarding packets in the stack setup.
Firmware upgrade for stacked switches - Cisco Meraki
2024年5月30日 · Hi Team, How can we upgrade the stacked Meraki switch's firmware? I just have network admin access, I don't have organization admin. Still, can I do the firmware upgrade for the switches separately, or can I do the staged upgrade with network admin access? Can we do the manual firmware upgrade...
Solved: How many stacking cables do i need to physically
2021年9月17日 · yes, I actually already looked at that and was part of what I was talking about documentation earlier. It shows one line from one switch to the next. then a second line from the bottom switch to the top switch, implying two different cables; however, the SKU itself has 2 cables as part of the assembly, hence my confusion.
Switching Fundamental Operations - The Meraki Community
Module 7: Maintaining Meraki-Managed Switch Networks (25 min) What you'll learn. The modules in this course will enable you to: Determine the past and present state of a Meraki-managed switch, switch network, and switch ports; Retrieve details about switch port connected devices; Generate and interpret switch network summary reports
Point to Point connectivity between 2 Meraki switches.
2024年12月19日 · You can't assign IP addresses directly to ports on Meraki switches. Instead, you set the IP addresses on VLAN interfaces, and then trunk the VLAN between the two switches. 0 Kudos
Switch firmware versions MS 16.7 changelog - Cisco Meraki
2023年11月1日 · Switches move LACP ports to an active forwarding state if configured. This can cause loops when connecting to an MS390 or other Catalyst switches unless the bundles are configured on the MS390/Catalyst switches first. All non-catalyst ports are configured in passive LACP mode so that loops do not occur between Meraki switches (always present)
Re: SFP-10g-SR-S Compatibility with Meraki Switches
Yes, the SFP-10G-SR-S is compatible with many Cisco Meraki switches that support 10G connections. It’s a short-range transceiver used for 10G speeds over fiber cables, typically up to 300 meters. Just make sure your specific Meraki switch supports 10G SFP+ modules, and you should be good to go!
Cisco Catalyst 9K Switches on Meraki Dashboard
2019年8月21日 · Hi Meraki Community, I have heard from a few very good sources that the Cisco Catalyst Switches (have) and will be appearing on the Meraki Dashboard with full functionality and configurations, I have several customers with Meraki and C9K Mix. Is there any news on this, apparently this has been s...
- 某些结果已被删除