Running welded wire fence uphill...how to? | Adventure Rider
2008年8月2日 · I'm putting in a test run of 4' welded wire (2"X4" mesh) fence 200' or so. I drove in 6' T posts (the angle iron posts not the cheapie stamped posts) 2' in the ground and am now unrolling the mesh, but my first 40' or so runs uphill on a little grade.
Installing FZ-1 Fuseblock - Looking for tail light wire for switched ...
2014年9月14日 · Working on installing the FZ-1 Fuzeblock fuse block on my 2013 R 1200 GSA. I figured that I'd posi-tap the switched wire into the tail light wire that is somewhere in the wire bundle to the left of the diagnostic plug. My wiring schematic is kinda hard to read to determine which wire is which. Any of you folks have experience going this route.
Installing GPS Wire and Heated Grips to ACC2 - Adventure Rider
2020年11月25日 · Collecting courage to install cruise control, gps wire and heated grips all in one shot. Gonna take the front apart only once. Cruise is simple enough, no questions. I have no electrical work background, I am dangerous, know just enough to cause trouble. I understand that both GPS wire and KTM OEM heated grips should go to ACC2, switched power.
KLIM Introduces X1 Alpha and GT1 Expedition Helmets
Both helmets feature a hand-laid 3K pre-preg carbon fiber shell, EPS construction, and Koroyd impact-absorbing material. Koroyd is a dual-walled welded material made up of straw-like structures, or cores, welded together. The cores crush homogeneously when impacted, without the rebound condition found when using EPS alone.
RebelX Ultralight Rally Tower Prototype Install | Adventure Rider
2024年10月11日 · Wire Stripper and Crimper; Connectors for managing wires, electrical or harness fabric tape, heat shrink tubing; Flat-bladed screwdriver or spudger for prying plastic tabs; Torque Wrench; Set of feeler gauges (to measure the top …
R80 turn signal wires routing? - Adventure Rider
2017年3月31日 · If you're wanting to route the wires like a naked /6-/7, the loom goes: - contact board - grommet out bottom of headlight (central)
LiveWire, Kymco Team-Up Displayed At EICMA (Sort Of)
2024年11月6日 · Taiwanese moto manufacturer Kymco and US-based LiveWire announced some details of their collaboration this week, and maybe, just maybe, it’s the news that Livewire needs to turn around.
How to install a Gerbings dual thermostat controller
2005年10月20日 · Lots of wire securing going on in this step. 1: I routed the power lead down to the battery. There is just enough room to get the fuse holder through the support brackets and existing wiring. No need to cut the cables. Do not connect them at this point. Wait until the end.
Can I hook a switched GROUND up to a relay? | Adventure Rider
2008年10月10日 · Now, to hook up your new horn you run a nice big piece of wire, say #12 from some 12V source to one of the other two prongs on the relay,(30) then, you run a wire from the other prong on the relay (87) to the new horn. Then need to run a wire from the ground lug on the horn to a good ground on the bike somewhere. Is this making sense?
R1150 Motronic Reset Time: 10 Minutes | Adventure Rider
2011年11月9日 · I had that sick feeling, what had I broken: was my new HES bad, had I broken a wire in the redressed harness, or was there a problem with the fuel tank reinstall. Checked the fuel line return volume, plenty of fuel. Checked the sidestand, and RID display, all normal. Fuel pump on with key on. Wiggled the wire harness.