Excalibur Tuning Resource - Scroll Saw Woodworking and Crafts …
In the forums and sometimes via email, we often see people asking how to adjust the Excalibur's front-to-back blade motion. I found myself explaining this process often.
Excalibur Adjustment Question - Scroll Saw Village
2019年10月6日 · You can fine tune it a bit by turning the big black knob a bit CW. That applies more tension to the blade. Then, you can unflip the lever and take the blade out of the top clamp and insert it in a hole or leave it as is and just start cutting.
Tuning Your Excelsior Or Excalibur Scroll Saw
Turning this knob raises and lowers the angle of the upper arm. If you make this adjustment after you have a blade attached at both ends, it will increase or decrease the tension by moving the upper arm. As soon as you undo the blade from one of …
21” Excalibur Scroll Saw—Thoughts on Initial Tune Up
2012年2月15日 · 21" Excalibur Scroll Saw-Thoughts on Initial Tune Up Every bench tool (with the possible exception of my drill press) required me to fine tune the tool before it was ready to use. Instructions for such requisite procedure were either included (as with the radial arm saw and the table saw) or readily available from a secondary source (my band saw).
My Next Scroll Saw - stevedgood.com
2013年2月14日 · My partner Keith wrote an article on fine tuning the Excalibur which may give you a little more information on it. The link to it is here: http://www.sheilalandrydesigns.com/articles/excalibur-tuning I wish you luck with whatever you choose. As with most things, you really do get what you pay for. Sheila
Excalibur 16 Tension Question - Scroll Saw Woodworking and …
2011年11月20日 · I have just purchased the same saw (1 month ago) and I noticed lot's of back to front movement, here is what I did to fine tune it: 1. Loosen the 3 screws holding the motor 2. Get a square piece of wood that will fit against the back of the blade 3. Apply the normal tension on the blade 4. Turn the speed to the lowest 5.
Thread specific to operating and set up of Excalibur saws - Scroll Saw ...
Hello, I have started this thread in order to learn how to operate, set up and fine tune my new Excalibur 21 and for the experience users of the different Excalibur models to help those with less experience.
Excalibur EX-30 Scroll Saw Part 1 - Woodworking Talk
2010年7月19日 · The EX-30 also provides a fine-tuning tension knob at the rear of the saw. I found that after the initial setup of the machine, I didn’t require the use of the rear knob. I would think that this is a good thing seeing that the second knob is over 30” away from you.
Excalibur blade ensionning - Scroll Saw Village
2019年12月30日 · The first thing is to make sure the arm is absolutely parallel to the table from front to back. Once that setting is done, you won't need to turn the big black knob at all. Unless you just feel that you need more tension. As was mentioned, the white plastic lever may be worn out too. Follow the instructions in the manual.
I need some help with my Excalibur!!! - Scroll Saw Village
Manually push the arm up and down with the square next to the blade and if the blade moves straight up and down then it is not the saw and it is your pushing technique. At times we get to pushing too hard and you are putting pressure where there should not be.
- 某些结果已被删除