89 YJ NO Start/No Crank (VIDEOS) - Jeep Enthusiast Forums
2017年7月23日 · Does the jeep turn on? It is possible to jump a starter by circumventing a defective solenoid and directly delivering a surge of electric current from the battery. To do this, get a screwdriver with a long shaft and an insulated rubber handle. Touch the blade of the screwdriver to the post leading to the starter.
89 YJ will not start - Jeep Wrangler Forum
2018年10月5日 · I have a carbureted 6 cyl, so I'm unfamiliar with the 4cyl FI YJs. From what I read on this forum though, the crank position sensor on top of the bell housing seems to be a common culprit. Try to find a new MOPAR CPS if you can.
1989 No start, No Crank (Video) - Jeep Wrangler Forum
2017年7月23日 · That's not a test of anything useful. Your symptoms most likely indicate a bad/discharged battery, bad/dirty battery cables, or a bad starter. Your battery may be fine, but your test is not a valid way to eliminate the battery as being the problem.
HELP! 89 Jeep YJ 4.2 died while driving cranks but won't start ...
2021年7月29日 · If it doesn't start, retard the timing past the original mark. Try to start the Jeep. If it starts, then you've jumped a tooth. If it doesn't start, return the distributor to the original mark and tighten the bolt. Just because it doesn't start advanced or retarded doesn't mean the timing chain doesn't need to be replaced.
89 yj crank no start - Jeeps.net Forum
2020年2月10日 · I have an 89 YJ 2.5 with a crank, no start issue. Has spark and injector signal, so I presume not a crank sensor or ecm problem. Did a compression test...3 cyls were 130-135 #4 cyl was 120, so thats an issue, but I wouldnt think it would cause it not to start. Fuel pressure is around 15psi with the key on, and about 22-25 when starting.
89 4.2 crank but no start | Jeep Wrangler YJ Forum
2024年5月6日 · check your alternator, check gap on plugs, and recheck timing after new dist. good luck, let us know how you come out. Alternator is pushing out 14.4 when it’s running back to the battery, already have changed the plugs and gapped them to .040 which is what I’ve read is good for the HEI. But will do.
1989 Jeep Wrangler won't start / stalls. - Jeep Enthusiast Forums
2006年8月15日 · I have a 1989 Wrangler Laredo with the 4.2L. Was running ok-to-fine. Changed the plugs, cap & rotor, cables, oxygen sensor, temp sensor, pre-heater hose, EGR valve, and PCV vavle (and added a new cat - to pass smog). Lately, it's been hard starting and once it starts, I have stalling issues.
1989 YJ 2.5 starts when cold but has trouble starting once …
2024年12月1日 · I have a 1989 YJ Wrangler 2.5L 4cyl with EFI. The problem is it starts fine when cold, but after you drive it for a while and then shut the engine off, it will not start. You crank it over and over with no start. After it sits and cools down for several hours it will start again. Please help with what might be causing this issue? Thanks Joe!
4.0l will turn over, no spark, has fuel. No Start. - Jeep Enthusiast Forums
2010年3月21日 · Begin with basic trouble shooting of the start and charge systems. Remove, clean, and firmly reconnect all the wires and cables to the battery, starter, and alternator. Look for corroded or damaged cables or connectors and replace as needed.
89' Cranks But No Start - Jeep Wrangler Forum
2017年5月1日 · I've got an 89' Wrangler (Islander) with a 4.2L Inline 6. I've had a HEI distributor, new computer and a fuel injection throttle body installed on it (in about 2008). It had issues starting in about 2011 when I parked it and it sat until now. It has fire, air, and fuel.
- 某些结果已被删除