[How-to]:Complete Air-Ride Plumbing/Wiring - S-10 Forum
2010年4月6日 · After spending the past few weeks going over every aspect of my air set-up, I realized that there was no COMPLETE diagram available online for how to wire/plumb a system. Sure, there were partial diagrams on SD, Viair, etc, but, nothing comprehensive. I designed these diagrams in two parts: valves and compressors.
Air suspension wiring schematic - CircuitBlaze
The wiring diagram serves as a guide to help you properly connect and configure all the necessary components for your air ride system. Key Components: Air Compressor: This is responsible for compressing air and filling the air ride system’s air tank. Air Tank: This stores the compressed air and provides a reservoir for the system to draw from.
Air Compressor/ACK – Wiring Diagram..... 4 Air Compressor/ACK – Service Parts ..... 5 Air Compressor/ACK – Tandem-Axle Plumbing Schematic..... 6
Ground Wire— The ground lead on the compressor should not be extended (if possible). Always connect ground leads direct- ly to the chassis (frame) of the vehicle. Any other grounding method may result in amperage fluctuations that can damage the compressor motor. Power Wire Type— Fine-stranded, copper wire is ideal for this use.
Instructions - EZ Air Ride
Here you will find installation, plumbing and wiring instructions for all of our EZ Air Ride kits. If you need further help, you can find more info below.
• Use the rubber grommets supplied on the feet of the compressor to reduce vibration. • A main power wire of 12AWG. or larger will be needed to supply each compressor. It will attach to the Red wire on the relay. The yellow wire on the relay will …
DETERMINE THE MOUNTING LOCATION FOR THE AIR COMPRESSOR - Provide ample air flow. - Protect from airborne debris and moisture. - If using the optional Frame Installation Kit (Part # 2497), consider the guidelines above, and follow kit’s instructions. PLAN INSTALLATION ROUTES FOR WIRING AND AIR LINES INTO CAB
Connect and test the system by running the air com-pressor for a short time to build up pressure in the air tank. The compressor will stop when the pressure reaches the “cut-out” pressure of the pressure switch. Inspect all air line connections for leaks with soap and water solution.
determine the mounting location for the air compressor - Provides ample air flow and is protected from airborne debris and moisture. - Mount close enough to the ECU to allow Wire Harness connections to reach.
• Attach the grey wire from the main power harness to the black wire on the primary compressor. The red wire connects to +12V. • Thomas Compressors (black) will require a 20 amp fuse (each). Mounting the Air Tank • The air tank can be mounted anywhere on the vehicle in any position, so long as the sensor is not pointed down. Having the sensor
- 某些结果已被删除